Analysis of quality problems of alloy saw blades

Alloy saw blades are widely used, and some problems are often encountered during use, such as breakage, reduced sawing quality, and short service life. So how do we deal with the problems of alloy saw blades? Below we analyze the root of the problem. 

1.Replacement and installation of saw blade: Many times when the staff is busy in production, when replacing the alloy saw blade, there will be no inspection after installation, resulting in incorrect installation of the saw blade or incomplete details, such as loosening or missing screws. Tighten, and some do not even figure out the direction, which seriously affects the use effect and life span! 

2.Model specifications are not paid attention to: the material or equipment that needs to be sawed is not a single one. There are many different equipment and materials that need to be cut and processed. Then you must pay attention to the selection of saw blades. Different materials and equipment are all There are corresponding cemented carbide saw blades, which cannot be mixed. Where the saw blades are placed, the saw blades of different models should not be too close, and try to separate them as much as possible.



3.Equipment problems: If the equipment has not been maintained for a long time, some minor problems will occur, which will affect the coordination between the saw blade and other components. Regular inspection and maintenance of the equipment will be carried out. One more thing, if the ampere meter is not set If it is correct, it will cause damage to the alloy saw blade and unstable equipment. 

4.The cleaning work is not in place: before the equipment is turned on or after it is finished, the whole machine should be cleaned up. If there are small iron pieces that are not cleaned off at the saw tooth part of the alloy saw blade, it is easy to cause tooth chipping! 

5.The alloy saw blade is handled with care: When the alloy saw blade is not mastered, it will sometimes fall, and sometimes it will touch other metal objects or hard objects. This is not good for the saw blade, once it is damaged Sawtooth will have a diffuse effect during cutting.

6.Speed is too fast: Any kind of saw blade has a certain range of speed when cutting. If it exceeds this rule, it will easily cause damage. For different equipment and materials, there are related speed rules. , Don’t arbitrarily adjust the speed because of the rush, unless the cutting cost of alloy saw blade is too low. 

7.The materials are not cleaned: Most of the time, the materials will be cut directly when they enter the factory. In fact, this is very unwise. I believe that everyone understands the truth. The materials have just been delivered, and the surface must be wrong. Clean, if you cut directly, it will increase the friction of the alloy saw blade, especially the unevenness. 

The above summarizes some of the reasons for the problems of some alloy saw blades, and I hope it will be helpful to everyone. Our company provides alloy saw blades with good quality and favorable prices. You can contact us if you need it.

Pre:Dressing of the grinding wheel

Next:Back To List

x
Get Price
Name
*Email
*Message